CTEK XS0.8 Acculader
(Elise, Exige, 340R, Speedster alle modellen)

€45.64 (€55.22 Inc TAX)

 
Indien u uw auto over een langere periode stilzet vraagt u min of meer om accu problemen... Met de hedendaagse Gel Accu's betekent het leeg laten lopen van de accu eigenlijk dat u een nieuwe moet kopen omdat de Accu nooit meer zo goed zal functioneren als ie deed.

Zoals te zien in onderstaande specificaties is de CTEK Batterij lader meer dan een gewone druppellader! CTEK staat erom bekend de wereld meest intelligente laders te produceren. De lader kent drie fases waarbij de laatste het meest belangrijk is om uw Accu 'in leven te houden'. Let wel.. een constante stroombron op de Accu (zoals vele goedkope druppelladers) betekent dat de accu steeds verder terug zal lopen in capaciteit.
CTEK meet de spanning op de Accu. Zodra de spanning begint te dalen pulseert de CTEK lader en conditioneert de Accu. Uw Accu vindt dit de beste behandeling!

Dit model is geschikt voor kleinere auto's zoals de Elise, Exige of 340R. Als u van plan bent deze lader te gebruiken voor meerdere auto's (grotere auto's) adviseren wij u het iets grotere model te gebruiken: de XS3600



Three Step Fully Automatic (IUoUp)

Electronic switch-mode
battery charger for
all 12 V lead-acid batteries, 1.2-32 Ah.
Maintenance charging, 1.2-100 Ah.

Technical specifications

FEATURES
Three Step Fully Automatic (IUoUp).
Charges lead-acid batteries (Wet, MF, GEL and AGM) from 1.2 Ah to 32 Ah, 1.2-100 Ah maintenance charging.
Maintenance pulse charging.
Increased battery life and performance.
Charges even drained batteries.
Pulse recover of lightly sulphated batteries.
Low ripple voltage (<10mV).
Delivered with two interchangeable connection sets, one with clamps, and one with eyelet terminals.
Compact design with mounting brackets
2 year warranty against manufacturing defects.

SAFETY FEATURES
Safe to use with sensitive electronics.
Sparkfree.
Short circuit and reverse polarity protected.
Double isolated.
Water resistant, outdoor use.
Progressive temperature protection.
Tested by SEMKO AB, in conformity with the following standards:
EN 60335-1, EN 60335-2-29, EN 55014-2, EN 55022, EN 61000-3-2 and EN 61000-3-3.

CHARGE CHARACTERISTIC
XS 800 Battery Charger
has a three step fully automatic charge profile, IUoUp:

1. Bulk Charge. Charging where 80% of the energy is returned. The charger delivers an almost constant current until the battery voltage reaches maximum level.

2. Absorption Charge. During absorption charging the voltage is held constant at the set voltage. In this period the current decreases as the battery approaches full charge.
3. Maintenance Pulse Charge. Maintenance phase, where the charger delivers a pulse if the battery voltage drops. The State of Charge is between 95% and 100%. This is the most careful maintenance mode for a battery that is connected for a long period of time (months).

Using the XS 800 will enhance battery life and ensure a high degree of operational safety.

BATTERY TYPES AND PROGRAMMING
With XS 800 you can charge batteries from 1.2 Ah to 32 Ah. You can also use it for maintenance charging for batteries from 1.2 Ah to 100 Ah.

TEMPERATURE PROTECTION
To protect the charger from overheating, the
XS 800 is equipped with a power delimiter. At raised ambient temperatures output power is reduced. The power will also be reduced if the charger should be accidentally covered. In this way the charger is protected from damage. The charger continues to operate but at a lower power output. When the ambient temperature drops the power will automatically rise again.

TECHNICAL SPECIFICATIONS
MODEL XS 800 - 12 V

INPUT VOLTAGE AC

220-240 VAC, 50-60 Hz

BACK CURRENT DRAIN*

< 1 mA

CHARGING VOLTAGE

14.4 V, nominal 12 V

RIPPLE**

10 mV rms, 12 mA (2%)

CHARGING CURRENT

0.8 A max

AMBIENT
TEMPERATURE

-20 C to +50 C. Automatic reduction of power at increased ambient temperature.

CHARGER
TYPE

Three step fully automatic IUoUp, with pulse maintenance mode.

BATTERY
TYPES

12 V lead-acid batteries
(Wet, MF, VRLA, AGM and GEL)

BATTERY CAPACITY

1.2-32 Ah
(1.2-100 Ah maintenance charging)

DIMENSIONS (L x W x H)

142 x 51 x 36 mm
INSULATION IP 65, (splash and dust proof)

WEIGHT

0.3 kg
*) Back Current Drain is what is draining the battery if the charger is connected without the power cord connected. XS 800 extremely low Back Current Drain is equal to 1 Ah/month. A normal figure for other chargers is 1 Ah/day, which could ruin your battery.

**) The ripple describes the quality of the current and voltage. A high current ripple heats the battery and shortens its life. A linear charger has a current ripple of 70 - 400 % which is much larger than the maximum 5 % for a modern sealed battery. High voltage ripple could harm other equipment, which is connected to the battery. XS 800 produces a high quality current with very low ripple. There is no need to disconnect the battery from the vehicle.

BULK CHARGING TIME
BATTERY SIZE
(Ah)
TIME
(h)
2 1,5
8 6
20 20
32 36

Model: CTEK800

Add to Cart:
 
 

Dit product is toegevoegd op Friday 01 July, 2005.

MANUFACTURERS

» AP Racing

» Hurricane

» Larini

» Nitron

» Pro-Alloy

» Richbrook

» Smartwax

» Willans

Copyright © 2020 Elise Shop. Powered by Zen Cart
4